Reconditioning of articulated hauler frame pivot tube, welding and line boring of worn tube to fit replacement nylon bushings. Restore worn grease channels, weld and reface both thrust facings.
Work completed to manufacturers repair procedure.
Reconditioning of Reach Stacker Boom, welding and line boring of heel pins.
Reconditioning of vibratory feeder, line boring to accept oversize eccentric bearing bushings to manufacturers service procedure.
Loader frame center pin reconditioning, welding and line boring to fit lower pin and upper spherical bearing.
Line boring of lower articulation pins on wheel loader.
Reconditioning of aluminum concrete truck conveyor section, line boring oversize to accept manufactures nylon bushings.
Repair of bent forklift axle, welding and lineboring of wear bushing bores and thrust counterbores to correct alignment. Hydraulic press installation of new wear bushings.
Reconditioning of forklift axle knuckles to except oversize bushings to manufactures repair procedure.
Reconditioning of excavator dipperstick, consisting of welding and line boring of worn bushing bores, also welding and remachining of worn side faces, hydraulic press installation of wear bushings.
Loader arm reconditioning, welding, line boring and press installation of wear bushings.
Reconditioning of articulated hauler frame, welding and line boring of worn center pin bores to fit new pins.
Repair of backhoe boom pin worked out during operation, straighten bent pin boss platework.
Welding and lineboring to restore alignment.
Grader mold board reconditioning welding, line boring, and press installation of wear bushings. Rt. 6 "Casey Highway" project. Dunmore, Pa.
Reconditioning of 6 way blade trununion, weld and line boring of thrust bearing bores, installation of bearings and welding of trununion retainer to manufacturers repair procedure.
Reconditioning of dipperstick, welding and lineboring of bucket pin bores to fit original wear bushings, hydraulic press installation of bushings.
Reconditioning of loader frame, welding and line boring of worn pin bores to fit new equalizer bar pin.
Ripper modifications, enlarge pin bores to fit larger diameter pins.
Wheel loader bucket welding and line boring of worn pin bores to fit new pins.
